2000 Toyota Tundra Suspension Problems

100 owners have reported suspension problems with the 2000 Toyota Tundra to NHTSA — 10% of all 1,011 complaints for this model year. The typical failure happened around 125,000 miles. That ranks #2 of 24 Tundra model years for suspension complaints (a typical year has 5). No suspension recall has been issued for this model year.

100complaints
125ktypical miles
0related recalls
6crashes
0fires
1injuries

Which parts fail

  • Front
    13
  • Rear
    12
  • Front › Control arm › Lower ball joint
    10
  • Front › Control arm › Upper ball joint
    3
  • Rear › Springs › Leaf spring assembly
    2
  • Front › Springs › Coil springs
    1

Components named in complaints (struts, shocks, control arms, ball joints, springs).

Mileage when the problem started

  • Under 25k
    23%
  • 25k–50k
    46%
  • 50k–75k
    1014%
  • 75k–100k
    1014%
  • 100k–150k
    1724%
  • 150k+
    2940%

Owner reports

Selected complaints filed with NHTSA by 2000 Toyota Tundra owners, lightly cleaned up (personal details are redacted by NHTSA).

The contact owns a 2000 Toyota Tundra. The contact stated that while driving at various speeds, he noticed that the front wheels would frequently turn to the opposite direction of what was intended. The vehicle was taken to an independent mechanic who diagnosed that the upper ball joints had failed and needed to be replaced. The independent mechanic replaced the upper ball joints with the same model; however, the failure reoccurred after the vehicle had been driven for less than 20,000 miles. The vehicle was taken to an independent mechanic who replaced the upper ball joints with the same model part; however, the failure persisted. The dealer was notified of the failure and informed the contact that they would only replace the ball joints with the original OEM ball joints. …

200,000 miles · Jan 2018

The contact owns a 2000 Toyota Tundra. The contact stated while driving approximately 15 MPH, he depressed the brake pedal, but the vehicle failed to engage. As a result, the contact crashed into a small tree that caused a dent in the front bumper. No injuries were sustained. No medical attention was required. A police report was not filed. The vehicle was towed to the contact's residence. The contact stated that upon inspecting the vehicle he noticed that the two lines in the master cylinder was missing the divider. The contact stated that he replaced the brake line, but the failure recurred. Additionally, the contact stated that on two separate occasions while making a left turn, the contact lost control of the steering wheel. The contact stated that upon inspecting the vehicle, he noticed that the ball joints had snapped and failed. No warning lights illuminated. …

Front › Control arm › Lower ball joint · 270,000 miles · Sep 2022

The contact owns a 2000 Toyota Tundra. The contact stated that there was an abnormal clicking sound coming from the front end of the vehicle while depressing the brake pedal. The vehicle was taken to an independent mechanic and was diagnosed with upper and lower ball joints failure. The contact was informed that the upper and lower ball joints and the axle needed to be replaced. The manufacturer was not notified of the failure. The vehicle was not yet repaired. The failure mileage was approximately 51,000.

51,000 miles · Feb 2026

On February 19, 2026, I contacted Hendrick Toyota Apex (1210 Laura Village Rd, Apex, NC 27523) to schedule repair for two open safety recalls on my 2000 Toyota Tundra (VIN: [redacted] ) under NHTSA Campaign #09V444, Toyota Campaigns BXD and BZD. The dealership incorrectly refused to perform either recall, stating that neither could be done in North Carolina because they only apply to cold climate states. This is incorrect - Campaign BZD was specifically created as a supplemental campaign to allow Toyota dealers outside the 20 cold climate states to inspect and repair covered vehicles. I was turned away on my first call. Only after calling back a second time to lodge a complaint did a different representative look up the recalls and confirm that Campaign BZD can in fact be performed at their location. …

Feb 2026

I pulled out of my bank's parking lot driveway making a right turn and the lower left ball joint failed and broke off causing the left front wheel assembly to collapse. The truck slid to a stop and blocked both the driveway and roadway. Police arrived shortly afterwards and made a report. Truck was not able to move on it's own and had to be towed to a repair shop. Broken ball joint inspected and then replaced by my mechanic. Further damage occurred to the left front fender and drivers door from the wheel assembly slamming into the fender. Front fender damage caused the drivers door to jamb shut. The damaged fender had to be pried back to release the door so it could open. …

Mar 2022

When I drive my vehicle it is difficult to apply the brakes on it and I feel like if I press too hard (which might be necessary if I need to suddenly stop) that the brakes might break or fail somehow. I have also noticed that underneath my truck, the frame is rotting out in certain areas and the leafs (steel long plates near the rear of the vehicle) is bending out of shape. There is a clanking noise near the front of the vehicle that concerns me as well when I pass through a small bump.

Oct 2023

Frame of the vehicle is starting to rust, clear coat paint is wearing off and is starting to chip with small spots of rust on the roof and hood, lower ball joint failure due to corrosion and degraded components. Unknown why the lower ball joint failed. Vehicle is not in the rust belt but definitely experiences corrosion and suspension issues.

Jun 2024

This complaint is to document severe frame damage due to corrosion my 2000 Toyota Tundra. The rusted frames of the 2000-2003 Tundra's are a well-documented problem that the Toyota Corporation has tried, unsuccessfully, to remedy in the past but continues to be a safety hazard to passengers and other innocent people when the frame finally fails. Some owners have been fortunate enough to have their frame replaced while others, like myself, have been told there is nothing available to remedy the problem. As seen in the attached pictures, I have significant corrosion along the frame walls where two pieces of steel were sandwiched together to reinforce the frame from where the gas tank is located to the rise where the bed attaches. These areas are crucial as the cross members of the frame attach to one another to form a solid body. …

Jan 2010

Previously recalled rusted cross member dropped spare tire on massachusetts 495 hitting the vehicle behind me. 8/18 Toyota inspected cross members and frame and told me they all needed to be replaced and since they already did it once during recall they have fulfilled obligation. Truck recieved vehicle undercoating per campaign has had one crossember replaced and fuel straps. Truck is one owner with 74K miles and garaged. Truck inspected in 2014 and in 2017 noted no corrosion at multi point inspections from Toyota. 8/14/18 dealership noted crossmembers had rot that must be welded at an outside shop. Toyota dealership would not quote repair and not work on truck. Have 2 children 3 and 5, wife and I need a safe resolution from Toyota. …

74,000 miles · Aug 2018 · crash

Vehicle driven: 2000 Toyota Tundra: on July 11, 2015 I was traveling at about 70 MPH in the far left lane when the front driver side tire and wheel broke off the vehicle. The front side of the truck impacted the pavement, and the truck began swerving. I tried to stop the truck, but the brakes were not functioning. Consequently, I then had to use my strength to steer the truck to the shoulder and wait for the truck to lose momentum since the brakes were not functioning. I managed to steer the truck to the shoulder after about a mile of trying to control the vehicle and waiting for it to slow down. I suspect that the lower ball joint on this vehicle are defective and LED to the accident. Newer models of this vehicle have been investigated by NHTSA for issues regarding the lower ball joints.

226,000 miles · Jul 2015 · crash

Suspension complaints in other Tundra years

’00’01’02’03’04’05’06’07’08’09’10’11’12’13’14’15’16’17’18’19’20’21’22’23’24’25’26100848163152769157292315433312247752
Suspension complaints per model year, Toyota Tundra.

Frequently asked questions

How common are suspension problems on the 2000 Toyota Tundra?

NHTSA has 100 complaints about the suspension of the 2000 Toyota Tundra, 10% of the model year's 1,011 complaints. The component named most often is front (13 mentions).

Is there a recall for 2000 Toyota Tundra suspension problems?

No. NHTSA lists no suspension recall for the 2000 Toyota Tundra, though it has 3 recalls for other components. If the problem is widespread, a repair may still be covered by an extended warranty or a manufacturer service bulletin — ask a dealer.

At what mileage do 2000 Toyota Tundra suspension problems start?

Half of the complaints with a recorded mileage happened before about 125,000 miles, and 3% before 25,000 miles.

Is it dangerous?

Owners linked 6 crashes, 0 fires and 1 injury to suspension problems on this model year. If you notice symptoms, have the car checked before driving further.

Source: U.S. National Highway Traffic Safety Administration (NHTSA) — owner complaints through October 20, 2026, recalls and defect investigations; fuel economy from the EPA. Complaints are unverified reports and are not proof of a defect. How we rate model years.