2022 Ford Explorer Collision Avoidance Problems

Which parts fail

• Warnings
  11
• Rearview system braking
  5
• Automatic emergency braking
  5
• Sensing system › Camera
  5
• Adaptive cruise control
  3
• Sensing system › Radar
  1

Components named in complaints (automatic emergency braking, adaptive cruise, lane keeping, backup camera).

Mileage when the problem started

• Under 25k
  778%
• 25k–50k
  111%
• 50k–75k
  00%
• 75k–100k
  111%
• 100k–150k
  00%
• 150k+
  00%

Owner reports

Selected complaints filed with NHTSA by 2022 Ford Explorer owners, lightly cleaned up (personal details are redacted by NHTSA).

The contact owns a 2022 Ford Explorer. The contact received notification of NHTSA Campaign Number: 23V022000 (Back Over Prevention) however, the part to do the recall repair was not yet available. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The contact stated while driving 15 MPH, the vehicle hesitated while accelerating and lost motive power. No warning light was illuminated. Additionally, the rearview camera was inoperable while reversing. The contact stated that the front driver's side seat inadvertently moved towards the steering wheel while driving. The headlights inadvertently turned off while driving at night. The contact stated that the transmission also failed to shift into gear. The vehicle was towed to the dealer, where it was diagnosed with unknown electrical failures due to faulty programming. …

I was backing up at low speed (less than 1 mph) to park by gently letting my foot off the brake to back. I was using the rear backup camera to gauge how far I could go back without striking the vehicle behind me. The screen showed video that I was still several feet away from the vehicle behind me when I felt a sudden bump. I stepped on the brake hard to ensure I was no longer moving but the camera still showed several feet between my rear bumper and the vehicle behind me. I put the vehicle in park and got out to verify that I had struck the vehicle behind me. I had. I returned to the driver's seat, put the vehicle back in reverse to see what the camera showed and now it appeared on the screen that my bumper was touching the vehicle behind me. …

In late October, 2022, when reversing in my driveway, I hit a tree. The rear camera alert system did not notify me of the presence / closeness of the tree (lived here almost 6 years, should know of tree but heavily rely on the camera and alerts to let me know if I'm too close). On another day, my husband was in the car with me and as I was reversing - he said "your alert didn't go off, this is probably why you hit that tree." I was unaware until today (1/30) that there is an active recall on my car for this issue. I had the damage fixed in November at Gerber Collision Center in Sebastian FL (Micco Rd). The cost of the fix was $2046 out of pocket (did not claim through insurance). Rear-driver side lamp, bumper, quarter panel. Invoice for repairs is included for detail in what all needed to be fixed. Pictures are not great and are after we taped the light on.

The contact owns a 2022 Ford Explorer. The contact received notification of NHTSA Campaign Number: 23V342000 (Back Over Prevention); however, the part to do the recall repair was not yet available. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The contact stated that while attempting to use the rear-view camera, a blue screen was displayed. The contact stated there was message on the instrument panel that the rear camera failed to operate as intended. The dealer was made aware of the failure but confirmed that parts were not yet available. The vehicle was not repaired. The manufacturer was made aware of the failure and informed the contact that parts were limited. The failure mileage was approximately 24,000. Parts distribution disconnect.

The contact owns a 2022 Ford Explorer. The contact stated while driving at various speeds, the Forward Collision Avoidance system activated without incident. The contact also stated that the Back Over Prevention camera would display several errors while in use. Additionally, the thermostat would indicate the wrong vehicle temperature causing the engine hot warning message to appear on the instrument panel. The thermostat and the Back Over Prevention camera sensors were both replaced. The Forward Collision Avoidance sensors were also replaced; however, the failure returned a month after repair. The manufacturer had been notified of the failure. The vehicle had yet to be repaired. The failure mileage was 7,700.

The contact owns a 2022 Ford Explorer. The contact stated that while reversing, the backup camera was slow to respond. The screen displayed an image of the vehicle. Additionally, there was an extreme amount of air entering the vehicle from the door seals. There were no warning lights illuminated. The vehicle was taken to the local dealer, who was unable to duplicate the failure, but the vehicle was not diagnosed or repaired. The dealer referred the contact to the manufacturer. The manufacturer was notified of the failure and referred her to the NHTSA Hotline. The failure mileage was approximately 5,100.

The contact owns a 2022 Ford Explorer. The contact received notification of NHTSA Campaign Number: 23V342000 (Back Over Prevention) however, the part to do the recall repair was unavailable. The local dealer was contacted, and it was confirmed that the part was not yet available. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the issue. The contact stated that the backup camera displayed a blue screen. The vehicle was not repaired. The failure mileage was 45,000. VIN tool confirms parts not available.

The contact owns a 2022 Ford Explorer. The contact stated that while reversing, the vehicle was shaking and slow to respond. The contact stated that the back over prevention camera screen was gray while the vehicle was rolling backwards. The contact stated that the back over prevention camera screen then turned blue. There were no warning lights illuminated. The contact called the local dealer, but the vehicle was not diagnosed or repaired due to a scheduling issue. The manufacturer was contacted and referred the contact back to the dealer. The failure mileage was approximately 18,000.

The contact owns a 2022 Ford Explorer. The contact stated that while the vehicle was in reverse, the rearview camera displayed a blank blue screen. The contact received notification of NTHSA Campaign Number: 26V123000 (BACK OVER PREVENTION); which was associated with the failure. However, the part to do the recall repair was not yet available. The local dealer was contacted. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the issue. The failure mileage was 6,000.

The contact owns a 2022 Ford Explorer. The contact stated that while the vehicle was parked, the rearview became inoperable. The contact stated that the rearview camera image was blank. The vehicle was taken to the dealer, where it was diagnosed that the processing module console had failed and needed to be replaced. The vehicle was not repaired. The manufacturer was made aware of the failure and referred the contact to the NHTSA Hotline for assistance. The approximate failure mileage was 76,000.

Related recalls

Collision Avoidance complaints in other Explorer years