Which parts fail
Components named in complaints (service brakes, ABS, rotors and pads, parking brake).
Mileage when the problem started
Owner reports
Selected complaints filed with NHTSA by 2011 Jeep Wrangler owners, lightly cleaned up (personal details are redacted by NHTSA).
The contact owned a 2011 Jeep Wrangler. The contact stated that while driving approximately 55- 65 mph when the vehicle in front suddenly applied its brakes. The contact attempted to apply the brake pedal however they were unable to stop fast enough and rear-ended the vehicle in front. The air bags failed to deploy. The vehicle was damaged and considered a total loss. The vehicle was towed and totaled. The contact had back and leg injuries that required medical attention. A police report was filed. The manufacturer was not made aware of the failure. The approximate failure mileage was 151,000.
There is a well known design flaw with the Jeep Wrangler JK parking brake. The parking brake handle is comprised of two springs, a clutch spring and a clock-spring, which keep tension on the parking brake lines. When this spring system fails, which it commonly does, the parking brake handle can be pulled all the way to the top without engaging the parking brake and holding the vehicle. The clutch spring has a extended tail which is supposed to be retained behind a small piece of upright stamped metal, the stop, in order to maintain tension on the spring, which enables proper operation of the parking brake lever. However, the piece of stamped metal is so small and inefficient, that the clutch spring tail flips past the stop, and the spring loses all tension, and in turn, the parking brake doesn't work. …
My abs control module is not functioning. The car does not stop properly in wet weather..the traction is effected. The abs control module was inspected by a dealership. The control module is non communicative to the abs module. The brake light, ABS light and the traction light are all on, all the time. I cannot get the vehicle inspected..If rain is dangerous, the upcoming winter is going to be treacherous.. I am extremely concerned for my safety. I'm having a difficult time finding the part for the year of my vehicle and I can't fix this problem with out mfr intervention. I wrote to the Jeep manufacturer in Michigan for assistance in locating this part and have not heard back. My vehicle is not the only vehicle to have this problem and there should be a recall because the breaking system not functioning is a huge safety issue.
Replaced the master cylinder for brakes and it worked for about 8 months then started leaking. More and more fluid was leaking and the brakes became very soft. Decided to replace the master cylinder again and upon inspection of the unit that was failing found that the manufacturing process had damaged the reservoir seals and nipples and it finally gave way to the leak. I tried reaching out to the manufacture but was told I would be contacted but nothing came of it. I have tried to repeatedly get in touch with them to no avail. I fear for anyone else having one of these poor workmanship master cylinders in their vehicle. Could have been a lot worse.
My jeep wrangler Abs module has failed and needs to be replaced. But Jeep decided not to make this part anymore and now me and a LOT of others can't get a new abs Module. My jeep is way too dangerous to drive now. When accelerating from a stop the vehicle barely kicks in like the tires don't know what direction to move. When I'm coming to a stop the breaks don't work right due to the ABS module. This is a big safety concern and jeep needs to be held accountable and fix this issue. This is a major issue and needs to addressed before people get into accidents. I'm sure some people already have.
There is a known issue for these Jeep Wrangler (in my case a 2011 model) with the ABS module going bad. Unfortunately, the part is unavailable for purchase. None to be found anywhere. If you contact Jeep they tell you they are being produced anymore and basically good luck. On top of that the companies that repair them can no longer do it because they cant get the chips to repair. We need the option of buying a new one OR at the very least they need to produce the chips to fix. SOME KIND OF SOLUTION! When the module is bad, the ABS system/stability control system doesn't work!
ABS Module problem that was affecting the performance of my 2011 Jeep Wrangler JKU to the point I almost had to stop driving it cause it wouldn't change out of 1st gear. This particular module in my jeep is on back order due to engineer review and the release date keeps getting pushed out. Dealer has to program VIN to match the Jeep if and when they ever get any in stock. The part needed is Anti-Lock Brake System Module - Mopar (68089120AB) I have found similar parts on Amazon, but I see prices from $500 - $3000.
I have an ABS control module internal failure, code C2200. There are no replacements available through dealer. Also, no shops to send module to for repair. My only option is EBay, where I have tried for replacement four times and cannot get the part number needed for my particular vehicle and year. The vehicle is not safe to commute to work, much less for traversing with my family inside.
ABS issues lights came on due to malfunctioning part. The part is unavailable and appears to no longer be available. Failure appeared a year ago and have been trying to find someone to replace. After taking to multiple shops, the last one finally told us the part is no longer available. With this being part of the braking system, it is very important to have working properly!
ABS Control module failure. According to multiple Jeep dealers, this part has been on back order "for a very long time." I am unable to source a new part to repair my vehicle. Jeep should be able to provide replacement parts for critical safety items.
Brake complaints in other Wrangler years
Frequently asked questions
How common are brake problems on the 2011 Jeep Wrangler?
NHTSA has 30 complaints about the brakes of the 2011 Jeep Wrangler, 6% of the model year's 485 complaints. The component named most often is foundation components › disc › caliper (1 mentions).
Is there a recall for 2011 Jeep Wrangler brake problems?
No. NHTSA lists no brakes recall for the 2011 Jeep Wrangler, though it has 10 recalls for other components. If the problem is widespread, a repair may still be covered by an extended warranty or a manufacturer service bulletin — ask a dealer.
At what mileage do 2011 Jeep Wrangler brake problems start?
Half of the complaints with a recorded mileage happened before about 50,000 miles, and 29% before 25,000 miles.
Is it dangerous?
Owners linked 2 crashes, 2 fires and 1 injury to brakes problems on this model year. If you notice symptoms, have the car checked before driving further.
Source: U.S. National Highway Traffic Safety Administration (NHTSA) — owner complaints through October 20, 2026, recalls and defect investigations; fuel economy from the EPA. Complaints are unverified reports and are not proof of a defect. How we rate model years.