Which parts fail
Components named in complaints (power steering, steering column, rack and pinion).
Mileage when the problem started
Owner reports
Selected complaints filed with NHTSA by 2015 Ram 2500 owners, lightly cleaned up (personal details are redacted by NHTSA).
The contact owns a 2015 Ram 2500. The contact stated that the vehicle was initially repaired under NHTSA Campaign Number: 19V021000 (Steering) at a local dealer; however, after the recall repair was performed, the vehicle was unable to receive a front alignment. The contact requested that the welds be removed to perform the alignment; however, several dealers and independent mechanics refused to remove the welds. The dealer had spoken with the manufacturer, but neither had offered any assistance. The Mopar manufacturer was also notified of the failure, and the contact was given a case number. The vehicle remained in the possession of the dealer. The failure mileage was approximately 106,000. The VIN was not available.
Over the past 2 years we have had issues with the front end particularly the drag link coming loose and major steering problems and major bouncing which resulted in purchasing 2 new sets of tires within 2 years. It was brought to our attention that there was a recall for the exact same issue from NHTSA Recall# V06 19V-021. Unfortunately our VIN number was not listed on the recall although our truck was having the same issue that was listed in the recall. I have contacted NHTSA and filed a safety complaint (Complaint# 11570103). Over the 2 years, we have had the drag link repaired twice which has cost us approximately $4700 in repair costs and tire replacement which could have been covered had our truck was listed under the recall. I have requested NHTSA to investigate and list our truck under the recall and is requesting refunds to the repairs I have already paid for. …
While driving down highway 65 mph, abs system activated causing right rear brakes to activate causing vehicle to activate steering control making truck head towards on coming traffic before able to control vehicle to shoulder of roadway. Would like to know if, when, and who and where any previous recall work has been performed to this vehicle, bought at a dealership in Oklahoma with check engine light on, told it was gas cap. Turns out it was not a gas cap, there was programming involved to remove the MIL function of brake system. ECM was sent to a 3rd party vendor and unlocked, afterwards the previous program was unlocked showing disabling of MIL functions for several functions. Vehicle is having issues with electrical radiator fan causing excessive heat in compartment, what was the fix for this by MFG? Was it to just program out the electric fan from coming on at high speed ? …
Our vehicle was not part of the safety recall V06/NHTSA 19V-21 recall based on VIN but have been experiencing same issues in the recall: Drag link separation can result in a loss of directional steering control. We have had several close calls of truck losing control. Vehicle currently in authorized dealership with the following diagnosis: Upon inspection, technician found the track bar to continuously back off, no known fix for this issue. Requesting our truck VIN [redacted] to be claimed under this recall. It is possible that other trucks that were manufactured from the same plant as ours could have been built with these defective parts. The contact is requesting that their vehicle be added to the safety recall in order for their truck to be repaired.
I was looking under my truck and noticed that I have a welded drag link, from my understanding this was supposed to be a temporary fix until a permanent remedy was available. This is supposed to be an adjustable drag link and I believe mine was welded out of adjustment and there is no way to adjust it now. The recall never was changed to replacement parts available they just welded them and went on. So now what the owners have to buy a complete replacement part to be able to adjust it?
I received a recall for 19v021000 I went an had the dealer fix the recall an they welding the jam nuts as a temporary fix now I'm unable to have alignment la done so what am I supposed to do for alignment an for tire wear the fix is me spending 850 dollars for different control arms that should've been fixed the first time. The dealer stated that it was a temporary repair until Chrysler came up with a solution but it's been three years an still no fix. Very unacceptable.
Where the traction bar mount is welded to the frame sheered off the frame while driving on the freeway causing me to lose steering control. Was not in an accident but I found that recall Safety Recall R46 / NHTSA 15V-541 for the two previous years was an issue. I have photos of the damaged traction control mount and will show where the separation was the same as the recall on 2013 and 2014 Rams.
The power steering pump bolts sheared off their mounts, causing a catastrophic and instant loss of my ability to steer and/or brake without great difficulty. While we were in a parking lot at the time, we had just crossed over a mountain pass, while hauling a 7200 lb travel trailer. Had it detached on a downhill, winding highway, this VERY easily would have been a fatal flaw.
My reimbursement for a recall I paid out of pocket was approved and a check was supposed to be sent to me, but has never been sent. I have called Mopar several times and they tell me they are sending the check to me but never do.
Traveling on highway 101 at 65-70 miles per hour, one quarter of the way into a hard left hand turn, the steering rod to the right front wheel came loose without any impact or any other form of road hazard. The threaded end disengaged from the turnbuckle nut leaving me with absolutely no steering. The out of control truck traveled into a turn out, up a hill, and into a ditch. The anti skid #2 kicked in, reducing my brakes, making the terrain eventually stop the truck. It was approximately 400 feet of travel after leaving the highway. Fiat-Chrysler was contacted (cair # [redacted]) and they sent an investigator (Bosch automotive service solutions) who took photographs and documentation after viewing the truck. I was not allowed to review the report. Then, Fiat-Chrysler respectfully declined any assistance associated with this matter. …
Related recalls
Steering › Linkages › Drag › Link › Connection
Chrysler (FCA US LLC) is recalling certain 2013-2018 Ram 3500 and 2014-2018 Ram 3500 Chassis Cab and Ram 2500 vehicles. The outboard steering linkage jam nut may loosen, allowing one end of the drag link to separate.
Remedy: Chrysler will notify owners, and dealers will check the steering linkage jam nut tightness, replacing the drag link assembly or welding the nut to the adjuster sleeve, free of charge. The recall began March 22, 2019.
Steering
Chrysler (FCA US LLC) is recalling certain model year 2015 RAM 2500 trucks, and RAM 3500 trucks and cab chassis. The affected vehicles may have inadequate welds securing the front track bar frame brackets, possibly resulting in the bracket components separating from the frame.
Remedy: Chrysler will notify owners, and dealers will weld on a new track bar frame bracket or replace the frame of the vehicle, free of charge. The recall began on September 14, 2016.
NHTSA investigations
Steering loss due to linkage separation
On December 17, 2018, NHTSA's Office of Defects Investigation (ODI) opened Preliminary Evaluation (PE) 18-016 to investigate the steering system on model year (MY) 2015 and 2016 Ram 2500 manufactured by FCA US, LLC (FCA). Four complaints were received alleging separation of the drag link, a steering linkage that connects between the right front steering knuckle and the pitman arm on the steering box output shaft.
Steering loss due to linkage separation
On December 17, 2018, NHTSA's Office of Defects Investigation (ODI) opened Preliminary Evaluation PE18016 to investigate alleged drag link failures in the steering system on model year (MY) 2015 and 2016 Ram 2500 trucks manufactured by FCA US, LLC (FCA).
Steering complaints in other 2500 years
Frequently asked questions
How common are steering problems on the 2015 Ram 2500?
NHTSA has 43 complaints about the steering of the 2015 Ram 2500, 20% of the model year's 215 complaints. The component named most often is linkages (1 mentions).
Is there a recall for 2015 Ram 2500 steering problems?
Yes — NHTSA recall 19V-021 (connection, Jan 25, 2019); NHTSA recall 16V-559 (steering, Jul 26, 2016). Recall repairs are free at authorized dealers.
At what mileage do 2015 Ram 2500 steering problems start?
Half of the complaints with a recorded mileage happened before about 40,000 miles, and 38% before 25,000 miles.
Is it dangerous?
Owners linked 2 crashes, 1 fire and 2 injuries to steering problems on this model year. If you notice symptoms, have the car checked before driving further.
Source: U.S. National Highway Traffic Safety Administration (NHTSA) — owner complaints through October 20, 2026, recalls and defect investigations; fuel economy from the EPA. Complaints are unverified reports and are not proof of a defect. How we rate model years.