Mileage when the problem started
Owner reports
Selected complaints filed with NHTSA by 2015 GMC Yukon owners, lightly cleaned up (personal details are redacted by NHTSA).
The contact owns a 2015 GMC Yukon Denali. The contact stated while driving at approximately 20 MPH, the vehicle started decelerating with a slight clunking sound coming from underneath the front passenger's side of the vehicle. The vehicle then lost motive power. The contact coasted to the side of the road and turned off the vehicle. After waiting for a while, the vehicle was started and the contact became aware that the instrument panel and all other electrical systems were activated as expected; however, the engine failed to start. The vehicle was towed to the dealer where it was diagnosed that there was a failure with the engine. The vehicle had not been repaired. The vehicle was then towed to an independent mechanic where it was confirmed that the engine had failed, and the starter needed to be replaced. …
The contact owns a 2015 GMC Yukon Denali. The contact stated that while driving 80 MPH, the vehicle hesitated, and failed to accelerate as intended while depressing the accelerator pedal. In addition, there was an abnormal knocking sound coming from underneath the passenger's side of the vehicle. The check engine warning light was illuminated. The contact arrived at the residence and used a personal diagnostic reader and retrieved information related to misfires in cylinder #2 and #4. The contact replaced the spark plugs and the ignition coils. The contact test drove the vehicle, and the check engine warning light later illuminated. The contact swapped the ignition coils; however, the failure persisted. The vehicle was taken to the dealer where it was diagnosed that Active Fuel Management (AFM) and Dynamic Fuel Management (DFM) had failed and caused the lifters to fail. …
The contact owns a 2015 GMC Yukon. The contact stated that while driving at an undisclosed speed, the vehicle inadvertently lost motive power. The contact was able to pull to the shoulder of the roadway, where the vehicle failed to restart. No warning lights were illuminated. The vehicle was towed to an independent mechanic, who diagnosed a failure with compression in cylinder 7, resulting in damages to the engine. The contact was informed that the engine needed to be replaced. The vehicle was repaired. After investigating the failure, the contact related the failure to NHTSA Campaign Number: 25V274000 (Engine and Engine Cooling), but the VIN was not included. The manufacturer was notified of the failure, a case was opened, and the contact was referred to the NHTSA Hotline for assistance. The failure mileage was 100,000.
The contact owns a 2015 GMC Yukon. The contact stated that while driving approximately 25 mph, the check engine warning light illuminated, and the vehicle started to vibrate abnormally. The contact had taken the vehicle to the dealer who diagnosed that the catalytic converter needed to be replaced. The vehicle had not been repaired. The manufacturer was not made aware of the issue. The approximate failure mileage was 120,058.
Started my 2015 Yukon XL, drove approximately 6 miles to get gas and was to head out onto the highway. After gassing up and starting engine it began to idle very rough with a shake going on and ticking noise. No previous signs of any issues. Slowly drove back to my house at 20 miles an hour and called Mandal GMC dealership. They suggested having it towed to them for inspection. Upon inspection they said the AFM/DOD #1 exhaust lifter was bad and needed replaced. They replaced all of Bank one lifters and said their was no damage to camshaft. Drove it that night after repairing it and everything seemed fine. They called the next morning and said when they started it up the ticking was back again. They then supposedly took off head cover and inspected the camshaft again and said it was damaged and I would need a new engine to the tune of $18,000.00. …
While traveling at highway speeds on Interstate 5 in Oregon, my 2015 GMC Yukon Denali experienced a sudden, catastrophic engine failure with zero advance warning. The vehicle instantly lost almost all propulsion and power while surrounded by high-speed traffic, creating an immediate and severe safety hazard on a major interstate. The engine began making a loud, severe knocking noise, and I was forced to navigate across lanes without adequate power to reach the shoulder. The vehicle was towed and inspected by Point S in Creswell, OR, where diagnostics confirmed a P0300 random/multiple cylinder misfire, with cylinder 4 specifically misfiring. Using a stethoscope and scanner to isolate the failure, technicians confirmed a catastrophic rod knock failure at the bottom end of the engine. …
Noticed a tick sound. Sent to dealer. Lifter failed. Bent push rod. Took it in Nov 24th. Charged $7,100. Fixed all lifters and bent push rod. Was turning around in my driveway and vehicle just shut off. Took it back to same dealer in Jan 27th. Bad lifter. Same push rod. Still in shop. That's two months and 2,000 miles and had same failure. That is absolutely ridiculous GM and I should be compensated for this. It has costed me $7100 dollars. They are fixing with a two year warranty but if the failures are so close together, who's to say it won't just keep happening. Not only is it a safety issue, it is hurting my finances. I drive this vehicle 2 miles to work at 25 mph, and religiously change the oil at 3,000 miles. It didn't even get an oil change before it failed again. I am not happy and GM needs to be sued for this. …
The vehicle developed a recurring cylinder #4 misfire with a flashing check-engine light, rough running, and reduced performance. Diagnostic code P0304 repeatedly returned. Replacing the #4 spark plug temporarily restored normal operation, but the misfire returned after a few hundred miles. The #4 plug was wet/oily, and fresh oil was found pooled in the #4 intake port while the other ports were dry. All eight spark plugs, ignition coils, and plug wires were replaced, along with the #4 fuel injector and both #4 valve-stem seals, but the misfire persisted. A valvetrain/lifter tick later became audible near 3,000 RPM. The failure has now been confirmed as a valvetrain failure that severely damaged/destroyed cylinder #4 and requires complete engine replacement. The vehicle is available for inspection upon request. …
With my child in the car, on a highway with no shoulder, I experienced lifter failure. It caused the vehicle shake and lose power with cars driving behind me at 55-60 MPH with nowhere to pull over. The engine just stopped as I was finally able to make it to a driveway safely. Problem was identified by dealership and my engine had to be rebuilt. I purchased the car second hand 3 months prior with no warning or symptoms. The car was inspected at the dealership by the extended warranty company rep. The extended warranty only cover a portion of the cost. The collapsed lifter cause damage to the camshaft and bent rods. The car only had 107,000 miles. If I were not able to pull off before the engine stopped, my daughter and I could've easily got rear ended on a Major state highway. The car was difficult to control due to the engine shaking the entire SUV.
2015 6.2l yukon lifter failure oil changed 2000 miles ago and lifter failed and possible cam damage due to AFM lifter failure vehicle has 115,000 Miles and Gm knows about these lifter failures that can blow engines and cause serious accidents due to rapid loss of power and controls that GM already knew paid alot of money as a certified pre- owned and failed to disclose lifter defects to their customers now at shop for complete inspection and now needs possible new engine when all service requirements were met now looking at thousands of dollars for repairs if known i would have not bought the vehicle. And deceiving GM customers , currently waiting for diagnostic in writing but the courts approved recall already from same issues on 2019 and newer but same lifters are in the same 2015 AFM system
Related recalls
Engine and engine cooling › Exhaust system
General Motors is recalling certain 2014 model year Chevrolet Silverado 1500 and GMC Sierra 1500 vehicles, and 2015 model year Cadillac Escalade and Escalade ESV; Chevrolet Silverado HD; and GMC Sierra HD, Yukon, and Yukon XL, equipped with a 4.3L engine or 5.3L engine.
Remedy: General Motors will notify owners, and dealers will reprogram the engine control module, free of charge. The recall began on January 16, 2014. Owners may contact Chevrolet at 1-800-222-1020 and GMC at 1-800-462-8782.
Engine complaints in other Yukon years
Frequently asked questions
How common are engine problems on the 2015 GMC Yukon?
NHTSA has 39 complaints about the engine & cooling of the 2015 GMC Yukon, 6% of the model year's 602 complaints.
Is there a recall for 2015 GMC Yukon engine problems?
Yes — NHTSA recall 14V-007 (exhaust system, Jan 13, 2014). Recall repairs are free at authorized dealers.
At what mileage do 2015 GMC Yukon engine problems start?
Half of the complaints with a recorded mileage happened before about 70,000 miles, and 25% before 25,000 miles.
Is it dangerous?
Owners linked 1 crash, 1 fire and 0 injuries to engine & cooling problems on this model year. If you notice symptoms, have the car checked before driving further.
Source: U.S. National Highway Traffic Safety Administration (NHTSA) — owner complaints through October 20, 2026, recalls and defect investigations; fuel economy from the EPA. Complaints are unverified reports and are not proof of a defect. How we rate model years.