2025 GMC Sierra 1500 Engine Problems

60 owners have reported engine & cooling problems with the 2025 GMC Sierra 1500 to NHTSA — 49% of all 122 complaints for this model year. The typical failure happened around 21,000 miles. That ranks #11 of 31 Sierra 1500 model years for engine complaints (a typical year has 18). No engine recall has been issued for this model year.

60complaints
21ktypical miles
0related recalls
0crashes
0fires
0injuries

Mileage when the problem started

  • Under 25k
    457%
  • 25k–50k
    229%
  • 50k–75k
    00%
  • 75k–100k
    114%
  • 100k–150k
    00%
  • 150k+
    00%

Owner reports

Selected complaints filed with NHTSA by 2025 GMC Sierra 1500 owners, lightly cleaned up (personal details are redacted by NHTSA).

The contact owns a 2025 GMC Sierra 1500. The contact stated that while driving at 35 MPH, there was an abnormal knocking sound coming from the engine. No warning lights were illuminated. The vehicle was towed to the dealer, where it was diagnosed with a rough idle code, and that the thermostat coolant housing had failed. The contact was provided DTC codes: B1A76 with failure Code 0X15 (pending), P05D, U0075, U0101, U0146, U020C, U0265, U1614, and U1616, and the codes were active. The vehicle was repaired. The contact picked up the vehicle from the dealer after hours, and when the contact started the vehicle, the abnormal knocking sound was still coming from the engine. No warning lights were illuminated. The contact stated that when the A/C was turned off, the abnormal sound ceased. …

18,000 miles · Dec 2025

The contact owns a 2025 GMC Sierra 1500. The contact stated that while driving approximately 5 - 10 MPH, the vehicle went into LIMP Mode and failed to properly accelerate, and the transmission unexpectedly downshifted. There was an electrical malfunction, which caused the transmission to downshift. An unknown message was displayed on the instrument panel. The contact stated that the network was not operating at the correct voltage due to the wiring harness. The engine light illuminated after the failure. The vehicle was towed on two occasions to the dealer to attempt to duplicate the failure. The dealer was unable to determine how to repair the vehicle. The vehicle was driven to the dealer in LIMP Mode. The manufacturer, General Motors, was contacted by the dealer, and the contact also reported the failure to the manufacturer. A General Motors service engineer had inspected the vehicle. …

35,000 miles · Sep 2025

The contact owns a 2025 GMC Sierra 1500. The contact stated that while stopped at a traffic light, the gear shifter was shifted to park(P) and the vehicle stalled. The message "START Engine" was displayed. The vehicle was restarted, and the Auto START/STOP feature was disabled by pressing the "A" inside an orange circle. The contact stated that on another occasion while reversing into the driveway, the vehicle stalled. The message "START Engine" was displayed on the screen. The dealer was contacted; however, the vehicle was not taken to the dealer or an independent mechanic. The vehicle was not repaired and the failure persisted. The manufacturer was not notified of the failure. The failure mileage was approximately 16,000.

16,000 miles · Nov 2025

The contact owns a 2025 GMC Sierra 1500. The contact stated while driving approximately 4 MPH and turning left into a parking spot, the vehicle independently accelerated. The contact stated that the brake pedal was depressed. The contact stated there was no warning light illuminated. The contact stated that the failure was intermittent, but the failure occurred while slowing down under 5 MPH and turning to the left. The contact had taken the vehicle to a local dealer; however, the failure was not duplicated. The vehicle was not repaired. The manufacturer was informed of the failure. The failure mileage was approximately 17,000.

17,000 miles · Jan 2025

The contact owns a 2025 GMC Sierra 1500. The contact stated that while driving at an undisclosed speed, the vehicle experienced a loss of automotive power. No warning light was illuminated. The vehicle was towed to a local independent mechanic, where it was diagnosed and determined that the engine had seized and needed to be replaced. The local dealer was contacted. The vehicle was not diagnosed or repaired. In addition, the contact related the failure to an unknown recall; however, the VIN was not under recall. The manufacturer was made aware of the failure. The failure mileage was approximately 75,000.

75,000 miles · Aug 2025

The contact owns a 2025 GMC Sierra 1500. The contact stated that while at a stop light waiting to make a left turn, the vehicle stalled. The vehicle failed to restart. No warning lights were illuminated prior to the failure. The contact stated that the failure was related to NHTSA Campaign Number 25V274000 (Engine and Engine Cooling). The vehicle was towed to the local dealer to be diagnosed, and the contact was informed that the engine had seized. The vehicle was not repaired. The manufacturer was not notified of the failure. The failure mileage was approximately 21,100.

21,000 miles · Aug 2025

The contact owns a 2025 GMC Sierra 1500. The contact stated that while driving at an undisclosed speed, the engine made abnormal knocking sounds. No warning light was illuminated. The vehicle was taken to the dealer, who discovered metal shavings inside the engine oil and determined that the crankshaft bearings had failed. The contact was informed that the engine needed to be replaced. The vehicle was not yet repaired and remained with the dealer. The manufacturer was made aware of the failure. The failure mileage was 26,634.

27,000 miles · Apr 2026

I have the 6.2 L87 with the 10 speed transmission in my 2025 Sierra. At cold start, when auto stop restarts the truck, when the truck downshifts under 20 mph down to 12 mph the engine or transmission makes a chirping/squeak/squeal sounds. Several repair attempts have been made, parts replaced. According to GM and their "field engineer" this is a "normal characteristic of the dfm system". They claim that it has to do with ignition timing. Not my first dfm truck, but it is the first to make this noise. There is not very many components in "the dfm system" that can make a metal on metal squeak/chirp/squeal sound other than lifters/pushrods, but the noise could be coming from the transmission/bell housing area. I am fairly certain this is an early warning sign of engine or transmission failure. Truck currently has 7,800 miles. …

Aug 2025

My GMC sierra AT4 with the 3.0L Duramax Diesel, has 1,500 miles on it, when the engine failed. I was traveling from [redacted] to [redacted] , towing a trailer, when the check engine light came, and the truck entered reduced power mode. It immediately slowed the truck without warning - which made for a very dangerous situation for all of the vehicles behind me and for my vehicle. After getting the vehicle and trailer to a dealer, disconnecting the trailer, and then getting the truck in the shop, the dealer defined the OBDII code as being P06DD - Engine oil pressure control solenoid valve stuck off. U0146 - Lost communication with central gateway module, and U1605 - Lost communication with side obstacle detection control module - right on private CAN Bus. …

May 2026

Rough idle started at 11,400 miles. Took to GMC dealer near me and had thrust bearing clearance measured. Measured .0054"(within spec). They released truck back to me. 19,400 mile oil change found large metal(non magnetic) slivers in the filter media. I cut filters to check for issues due to known issues with this engine(metal). I called gmc corporate, i was told to not drive the truck. I paid out of pocket for the tow 142 miles away. Dealer told me they checked thrust bearing and came in at .0055", no noises, and no check engine light. Idle is very rough on start up. GM corporate stated a service advisor will call. Never got a call. I have sent and displayed the evidence and offered to show oil filter contents to both dealer and corporaten both have not done anything about this safety issue. This is a SEVERE safety issue. …

Jun 2026

NHTSA investigations

Loss of motive power due to engine failure post recall remedy

NHTSA investigation EA26005 · opened Aug 20, 2026 · open

On January 16, 2026, the Office of Defects Investigation (ODI) opened Recall Query RQ26001. This investigation was opened to assess the remedy effectiveness of Recall 25V-274. ODI has received complaints alleging engine failure in vehicles after the recall remedy had been completed, whether that remedy involved an oil viscosity change or a complete engine replacement.

Engine complaints in other Sierra 1500 years

’96’97’98’99’00’01’02’03’04’05’06’07’08’09’10’11’12’13’14’15’16’17’18’19’20’21’22’23’24’25’26113765261314826201715187872854159723312573672652312186098
Engine complaints per model year, GMC Sierra 1500.

Frequently asked questions

How common are engine problems on the 2025 GMC Sierra 1500?

NHTSA has 60 complaints about the engine & cooling of the 2025 GMC Sierra 1500, 49% of the model year's 122 complaints.

Is there a recall for 2025 GMC Sierra 1500 engine problems?

No. NHTSA lists no engine & cooling recall for the 2025 GMC Sierra 1500, though it has 1 recall for other components. If the problem is widespread, a repair may still be covered by an extended warranty or a manufacturer service bulletin — ask a dealer.

At what mileage do 2025 GMC Sierra 1500 engine problems start?

Half of the complaints with a recorded mileage happened before about 21,000 miles, and 57% before 25,000 miles.

Source: U.S. National Highway Traffic Safety Administration (NHTSA) — owner complaints through October 20, 2026, recalls and defect investigations; fuel economy from the EPA. Complaints are unverified reports and are not proof of a defect. How we rate model years.