2024 Chevrolet Colorado Brake Problems

Mileage when the problem started

Owner reports

Selected complaints filed with NHTSA by 2024 Chevrolet Colorado owners, lightly cleaned up (personal details are redacted by NHTSA).

The contact owns a 2024 Chevrolet Colorado. The contact stated while driving 10 MPH and approaching a stopped traffic, the contact stated that the sun temporarily blinded his vision of the roadway. The contact depressed the brake pedal, but the vehicle failed to respond and crashed into a stopped motorcycle, causing the motorcycle and the motorcyclist to fall to the ground. Additionally, the contact stated that the vehicle was designed with the Forward Collision Avoidance: Automatic Emergency Braking (AEB) system, which failed to engage as designed. The motorcycle rider was able to escape the scene, while the contact's vehicle continued to move forward and to drive over the rear end of the motorcycle. The motorcycle was damaged and could not be ridden. …

The contact owns a 2024 Chevrolet Colorado. The contact stated that while driving on several occasions at various speeds, and the brake pedal was depressed the pedal remained floored. The contact stated that the vehicle eventually slowed down on its own and came to a complete stop. The was towed to a dealer where it was diagnosed that the master cylinder needed to be replaced. The vehicle was repaired but the failure reoccurred a little over a month later. The vehicle was towed back to the same dealer where it was diagnosed that the battery was dead and the battery needed to be replaced. The vehicle was repaired but the failure reoccurred approximately 17 days later. The vehicle was taken to the same dealer where it was diagnosed that the drivers door wire harness needed to be replaced due to an electrical issue that killed the battery. …

While driving in heavy and slow moving traffic at approximately 15 mph, the vehicle in front stopped. The forward collision and automatic emergency braking failed to activate. These safety features are not a replacement for active driving attention, but if they properly function and activate, they could have prevented the rear end collision that occurred.

Component/system issue: Intermittent loss of power assist to brakes after auto start-stop startup. Safety Risk: Unable to use brakes normally. Requires hard brake pedal pumping to get vehicle to stop. Reproduced by others: No. Doesn't happen every time. It has happened a total of three times (so far). Inspected by manufacturer: Yes. The first time, the dealer found low voltage DTC set. Replaced battery. Second time, dealer found low voltage DTC (P 0562) set. They contacted GM TAC who provided a file to patch the radio software. Third time, other (possibly related) electronics issues were also present which caused the vehicle to enter limp mode every time it's driven. They've replaced the ECU and the accelerator pedal, neither of which fixed that issue. They are now awaiting a wiring harness from GM to see if that is the root cause. …

At ~20,300 miles, severe chassis and steering wheel vibration occurred during high-speed highway descents while braking. Safety risk: reduced steering control at highway speed. The vehicle was inspected by a franchised Chevrolet dealer in Lakewood, CO. The technician's written service notes document rear rotor Lateral Runout (LRO) of 0.006 inches against GM's maximum allowable specification of 0.002 inches per GM Service Bulletin 00-05-22-002 - 3x the engineering limit. The defect was confirmed in dealer documentation and is available for inspection. After I identified this discrepancy, the Service Manager claimed the technician meant 0.006 mm (metric). Photographic evidence from the dealer's own diagnostic video shows a dial indicator clearly labeled in 0.001-inch increments with the needle resting on the 6th tick mark. …

The vehicle is registered to me; my mother was the driver at the time of the failure. At ~2,963 miles, the truck developed intermittent check engine and ABS warning lights. The dealer pulled DTC C058A (brake system control module) and P25A2. Per GM bulletin PIT6012A, the battery was replaced and a brake plunger motor sensor learn was performed. The same codes returned within weeks. The dealer then diagnosed internal failure of the brake master cylinder and reservoir, documented the vehicle as "unsafe to drive," and replaced both under warranty. The truck sat at the dealer over six weeks due to a nationwide parts backorder. Repairs were completed April 4, 2025. On May 2, 2025, at ~6,500 miles, the driver was traveling downhill on a city street in the rain at roughly 20 mph. The brake pedal suddenly became hard and resistant. …

ABS check engine light came on after initially taking the vehicle in because of the brakes feeling weird and making noise. This similar issue has been experience by multiple users reported on a Chevy Colorado group page on facebook to include 2 cases of individuals, one with a Colorado and another with a GNC Canyon, both GM vehicles, that had their brakes fail while operating the vehicles. This was a concerning issue because, in my case, while I drove the vehicle, I was able to punch the brake pedal all the way to the floor while the vehicle was slowing down. The vehicle and part were inspected about 3 different times with the final time, and with video proof of an odd noise it was making, which then caused the dealership service department to actually check the brake pump which then they found to be faulty and needed replacing. …

We purchased a used 2024 Chevy Colorado WT with a little over 4,500 miles on April 9th. A couple of days later before starting the vehicle the brake pedal would sink all the way down to the floor. This happened twice. So I made a service appointment with the Chevy dealer on April 14th. I told the service advisor that the brake pedal sank to the floor twice before starting the vehicle. He said they would take a look at it. When I went to pick up my vehicle the next day, the service advisor said the technician could not duplicate the problem. That same day, the brake pedal sank to the floor before starting the vehicle. So I made another service appointment the following week on April 23rd. I have videos to prove that the brake pedal would sink all the way to the floor before starting the vehicle. …

On the afternoon of [redacted], I had an interesting incident in a parking lot while slowly pulling into a parking spot. As I began braking, the brake pedal suddenly sank to the floor, forcing me to engage the emergency brake to stop the vehicle. After restarting the truck, the pedal firmness returned, but I noticed a peculiar sound, likely originating from the ABS pump or solenoids. No warning lights illuminated on the dashboard, and no error codes were detected with my scanner. Additionally, I've observed that the front driver's side wheel has significantly more brake dust compared to the passenger side. I brought this issue to the attention of the service advisor at Boulevard GMC in Signal Hill, CA. Boulevard GMC informed me that brake parts are currently on a nationwide backorder, and there is no estimated time of arrival for when GM will supply dealerships with replacement parts.

I purchased this truck new in March of 2024, in May I was at a Starbucks drive-thru and lost all brakes. While slowing down at the window the pedal went to the floor and my dash light up like a Christmas tree. I pulled into a parking spot and shut the truck off for about 5 minutes. When I turned the truck back on the lights were gone and the truck seemed fine, so I drove home. The next day I was picking up my kids from school when in the pickup line the same issue happened. I lost my brakes, the dash lit up, and the truck started rolling forward in the pickup line. I had to push on the brake pedal as hard as I could to make the truck stop. I called the dealer and had the truck taken there. The truck was there for several days and I was told the master cylinder and brake control module were replaced. …

NHTSA investigations

Brake complaints in other Colorado years