Most common 2010 BMW 128i problems
Share of the 22 complaints; one complaint can involve more than one system. "~" is the median mileage when the problem started.
BMW 128i complaints by model year
Best 128i years: 2008, 2010, 2009. Years to avoid: 2013, 2011, 2012. Compare all years →
2010 BMW 128i recalls (7)
Engine and engine cooling › Exhaust system › Emission control › Crankcase (pcv)
BMW of North America, LLC (BMW) is recalling certain 2008-2013 1 Series Coupe (128i); 2007-2013 3 Series Coupe (328i, 328xi, 328i xDrive); 2007-2010 X3 SAV (X3 3.0si, X3 xDrive30i); 2008-2013 1 Series Convertible (128i); 2006-2011 3 Series Sedan (325i, 325xi, 328i, 328xi, 328i xDrive, 330i, 330xi); 2006-2012 3 Series Wagon…
Remedy: This recall supersedes and expands previous NHTSA recalls 17V-683 and 19V-273. Dealers will install an electrical wiring harness with fuse protection for the PCV Valve heater in potentially affected vehicles, free of…
Air bags › Frontal › Driver side › Inflator module
BMW of North America, LLC (BMW) is recalling certain 2008-2013 128i and 135i Convertibles, 128i, 135i, and M Coupes, 2007-2010 X3 30si and X3 xDrive30i, 2013-2015 X1 sDrive28i, X1 xDrive28i and X1 xDrive35i, 2007-2013 328i, 328i xDrive, 335i, 335is, 335i xDrive and M3 Coupes, 2006-2011 328i, 328xi, 328i xDrive, 325i, 325xi,…
Remedy: BMW will notify owners, and dealers will replace the driver air bag. On X5 and X6 vehicles, only the inflator will be replaced. All repairs will be performed free of charge. The recall began March 11, 2020.
Electrical system › Wiring
BMW of North America, LLC (BMW) is recalling certain 2008-2012 BMW 128i, 135i, 135is Coupes and 128i, 135i Convertible vehicles. The wiring and electrical connectors in the blower-regulator wiring harness may overheat.
Remedy: BMW will notify owners, and dealers will inspect the blower-regulator wiring harness, and replace it with a new part, free of charge. The recall began October 4, 2019.
Engine and engine cooling › Exhaust system › Emission control › Crankcase (pcv)
BMW of North America, LLC (BMW) is recalling certain 2008-2011 128i and 2007-2011 328i, 328xi, 328i xDrive, 525i, 525xi, 528i, 528xi, 530i, 530xi, X3 3.0si, X3 xDrive30i, X5 xDrive30i, Z4 3.0i, Z4 3.0si and Z4 sDrive30i vehicles. The heater for the positive crankcase ventilation (PCV) valve may short circuit.
Remedy: BMW will notify owners, and dealers will replace the PCV valve heater, free of charge. Interim letters were mailed on November 27, 2017. Owners will receive a second notification by the end of October 2018.
Air bags › Frontal › Driver side › Inflator module
BMW of North America, LLC (BMW) is recalling certain model year 2008-2013 128i and 135i coupes and convertibles and 1 Series M coupes, 2006-2011 325i, 325xi, 328i, 328xi, 328i xDrive, 330i, 330xi, 335i, 335xi, 335i xDrive Sedans, 2009-2011 335d sedans, 2006-2012 325xiT, 328i and 328xi sports wagons, 2007-2013 328i, 328xi, 328i…
Remedy: BMW will notify owners, and dealers will replace the driver's frontal air bag module or inflator depending on the vehicle model, free of charge. The recall began March 9, 2018.
Engine and engine cooling › Engine
BMW of North America, LLC (BMW) is recalling certain model year 2010-2011 128i Coupe, 128i Convertible, 328i Sedan, 328i xDrive Sedan, 328i Coupe, 328i Convertible, 328i Sports Wagon and Z4 sDrive 30i, 2011-2012 135i Coupe, 135i Convertible, 335i Sedan, X5 xDrive 35i, and X6 xDrive 35i, 2011 335i xDrive Sedan, 335i Coupe, 335i…
Remedy: BMW will notify owners, and dealers will replace the four VANOS housing bolts for both VANOS units (intake and exhaust), free of charge.
Show 1 more recall
Electrical system › Wiring › Fuses and circuit breakers
BMW is recalling certain model year 2008-2012 1-Series coupes and convertibles manufactured December 2007 through September 2011; and 2007-2011 3-Series coupes and convertibles manufactured March 2007 through October 2011; 2007-2011 3-Series sedans manufactured March 2007 through October 2011; 2007-2011 3-Series sports wagons…
Remedy: BMW will notify owners, and dealers will replace the positive battery cable connector and secure it with an improved method, free of charge. The recall began on March 13, 2013.
NHTSA defect investigations
Federal safety investigators have looked into a possible defect involving the 2010 BMW 128i:
Desiccated Air Bag Inflator Rupture
From 2000 through 2017, Takata produced millions of air bag inflators using two types of phase-stabilized ammonium nitrate ("PSAN") propellant -- propellant 2004 and propellant 2004L. After prolonged exposure to high temperature cycles and humidity, inflators using propellant 2004 can degrade, causing the propellant to burn too quickly when ignited.
What 2010 BMW 128i owners say
Engine & cooling
The contact owns a 2010 BMW 128I. The contact stated that while driving at a slow speed and pulling into the driveway, the vehicle stalled. While driving on two occasions, the vehicle lost motive power and stalled. The check engine and other unknown warning lights were illuminated. Additionally, door and trunk failed to open. The contact's husband checked the vehicle and noticed there was power being distributed to the battery. The vehicle was taken to the local dealer, who was unable to duplicate the failure. While the vehicle was still at the local dealer, it was diagnosed that the CAS module needed to be replaced. The vehicle was repaired, but the failure recurred. The contact stated that the failure was related to NHTSA Campaign Number 23V707000 (Engine and Engine Cooling). The manufacturer was contacted, but no assistance was provided. The failure mileage was approximately 100,000.
The contact owns a 2010 BMW 128I. The contact stated while driving 60 MPH, there were unknown warning lights illuminated. The contact was able to continue driving; however, the failure reoccurred while driving. Additionally, the contact stated that the vehicle was experiencing excessive oil consumption. The vehicle was taken to an independent mechanic where it was diagnosed that the PCV valve had failed. The independent mechanic associated the failure with NHTSA Campaign Number: 22V119000 (Engine and Engine Cooling) however, the part to do the recall repair was not yet available. The local dealer was contacted. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was not made aware of the failure. The vehicle was not repaired. The failure mileage was approximately 110,000. VIN tool confirms parts not available.
Air bags
I have contacted BMW multiple times to come out and perform all 3 recalls. They said they would call back for details specific date to send out a certified mechanic to remedy the recalls. My wife never got a call back. I live over a hundred miles from any dealer on the VA and WV state lines. I can't afford to take time off to bring the car to them.
I called BMW beverly hills several times since I owning the car. I have taken it in because I received a recall letter and it seemed to have an electrical shortage. I told them I did not feel safe driving the car with a potential electrical issue and air bag defect. I dropped off my car 2 times. Never got an update. No one went over what was done to to the car. They wanted me to buy an extended warranty. After expressing several times and dropping off my car 2-3 times, they never called me back or responded... I had a car accident in late November or early December. Thank god my airbag did not deploy but I feel completely unsafe driving my car because I do not believe the electrical issue I complained about and the airbag I am waiting to be replaced. Electrical: when it is stationary it is having electrical issues. Turning it on is an issue. …
2010 BMW 128i engines & fuel economy
| Engine | Transmission | Drive | MPG city / hwy / combined |
|---|---|---|---|
| 3.0L 6-cyl | 6-speed automatic | RWD | 18 / 28 / 22 |
| 3.0L 6-cyl | 6-speed manual | RWD | 18 / 28 / 22 |
EPA ratings. Class: Subcompact car.
Frequently asked questions
Is the 2010 BMW 128i a good car?
Based on 22 owner complaints filed with NHTSA, the 2010 128i rates better than average: 58% fewer complaints than a typical year of the 128i at the same age. It is one of the best 128i years by this measure. Complaint counts don't account for sales volume or individual maintenance, so have any used car inspected before buying.
What is the most common problem with the 2010 BMW 128i?
The engine & cooling — 10 complaints, 45% of all complaints for this model year. Next are the air bags (9) and body & structure (2).
How many recalls does the 2010 BMW 128i have?
There are 7 recalls for the 2010 BMW 128i, the most recent from March 2, 2022 (crankcase (pcv)). Recall repairs are free at any authorized dealer — check whether yours has been done with the VIN recall check.
What are the best and worst years of the BMW 128i?
The best years by complaints, compared at the same age, are 2008, 2010 and 2009. Years to avoid or approach with caution: 2013, 2011 and 2012. See the full BMW 128i years comparison.
At what mileage do 2010 BMW 128i problems happen?
The median mileage reported in complaints is about 100,000 miles; 20% of problems with a recorded mileage started before 50,000 miles.
Source: U.S. National Highway Traffic Safety Administration (NHTSA) — owner complaints through October 20, 2026, recalls and defect investigations; fuel economy from the EPA. Complaints are unverified reports and are not proof of a defect. How we rate model years.