2007 Mini Cooper Electrical Problems

Mileage when the problem started

• Under 25k
  00%
• 25k–50k
  17%
• 50k–75k
  429%
• 75k–100k
  214%
• 100k–150k
  643%
• 150k+
  17%

Owner reports

Selected complaints filed with NHTSA by 2007 Mini Cooper owners, lightly cleaned up (personal details are redacted by NHTSA).

The contact owns a 2007 Mini Cooper. The contact received notification of NHTSA Campaign Number: 23V337000 (Electrical System); however, the part to do the recall repair was unavailable. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The contact stated the key fob failed to lock and unlock the vehicle, causing the contact to manually lock and unlock the vehicle. The contact also stated that the radio would change stations or power off independently. The vehicle had been taken to an electrician who referred the contact to the dealer. The dealer was contacted. The manufacturer was made aware of the failure. The failure mileage was 153,000. VIN tool confirms parts not available.

The contact owns a 2007 Mini Cooper. The contact stated while operating the vehicle, the check engine, ABS, and Dynamic Stability Control (DSC) warning lights remained illuminated, and the vehicle lost motive power and stalled. The vehicle was taken to the local mechanic who diagnosed that the foot well control module was faulty and needed to be replaced. The vehicle was not yet repaired. The local dealer was notified of the failure and the contact was informed that the VIN was not included in NHTSA Campaign Number: 23V337000 (Electrical System). The contact stated that the vehicle had experienced the failure listed in the recall. The manufacturer was not yet contacted. The failure mileage was 130,000.

The contact owns a 2007 Mini Cooper. The contact stated that while driving at an undisclosed speed, the engine seized. No warning lights were illuminated. The vehicle was towed to the residence. The contact, who was an independent mechanic, researched and diagnosed the failure with water damage to the junction box electronics. The manufacturer was made aware of the failure but provided no assistance. The contact referenced an unknown recall that had a similar failure description; however, the VIN was not under recall. The contact was advised to contact the NHTSA Hotline to report the failure. The failure mileage was approximately 116,000.

What happened: Vehicle has experienced failure of the Footwell Control Module (FRM) and associated wiring harness in the driver footwell area, consistent with NHTSA Recall 23V-337. Symptoms: Exterior lights (headlights / taillights) remain illuminated far longer than normal after vehicle shutoff, sometimes not turning off at all. Inspection revealed melted wiring, melted connector plugs and receptacles for headlight/taillight circuits. Water was found in driver side footwell in the past / under carpet padding. Carpet pad is saturated. This is the same failure mode described in Recall 23V-337: "Due to a number of contributing factors, over time, the FRM could become susceptible to corrosion. …

The open recall for this vehicle has been open for 15 months now. Meanwhile my wife's car remains broken down with a bad footwell module due to the exact reason the recall is being issued. I contacted mini and they said I'd have to pay for repairs out of pocket and apply for reimbursement after they come up with a remedy. I have issues with this for a few reasons. First, the repair is costly. Second, it's already been over a year since the recall has been issued, and still no remedy so who knows when they'll actually have one. Third, they said that even if I pay for repairs out of pocket there's no guarantee I'd get reimbursed for them. In my opinion, for something as serious as this recall, the manufacturer should be on the clock to determine the remedy and repair customers cars. …

The authorized dealer performed a non-compliant remedy for Safety Recall 23V-337. The initial repair resulted in melted wires and a charred connector due to high resistance. The dealer's subsequent re-repair utilized an un-staggered cluster of approximately 8 inline crimp connectors in a single tight bundle.This directly violates BMW Factory Repair Standard ISTA/AIR 61 13, which explicitly mandates: 'Arrange individual interfaces in an offset manner when repairing multiple cables. The wiring harness thus does not become too thick at the repaired point.' By failing to offset the splices, the dealership created a thick, bunched thermal mass that traps heat and strains the circuits, leaving an active passenger cabin fire hazard intact. Delivery has been officially refused

My Mini Cooper was rendered unsafe to drive as most of the exterior lights (i.e., headlights, brake lights, turn signals) stopped working--all at once. A local mechanic verified that the electrical short resulted from a severely corroded Footwell Control Module, which is the subject of the recall (Recall No. 23V-337, July 2023) for which a "Remedy is Unavailable." When contacted, a case management specialist of BMW of North America could tell me only that a remedy is not yet available. Again, the car is unsafe to drive as it lacks exterior lighting. As such, I am forced to purchase another vehicle as the Mini Cooper sits unusable.

The contact owns a 2007 Mini Cooper. The contact received notification of NHTSA Campaign Number: 23V337000 (Electrical System) however, the part to do the recall repair was not yet available. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The dealer was made aware of the issue and confirmed that parts were not yet available. The manufacturer was made aware of the issue and confirmed that parts were not yet available. The contact had not experienced a failure. VIN tool confirms parts not available.

The contact owns a 2007 Mini Cooper. The contact received notification of NHTSA Campaign Number: 23V337000 (Electrical System) however, the part to do the recall repair was not yet available. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The dealer was made aware of the issue and confirmed that parts were not yet available. The manufacturer was made aware of the issue and confirmed that parts were not yet available. The contact had not experienced a failure. VIN tool confirms parts not available.

The contact owns a 2007 Mini Cooper. The contact received notification of NHTSA Campaign Number: 23V337000 (Electrical System) however, the part to do the recall repair was not yet available. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The dealer was made aware of the issue and confirmed that parts were not yet available. The manufacturer was made aware of the issue and confirmed that parts were not yet available. The contact had not experienced a failure. VIN tool confirms parts not available.

Related recalls

Electrical complaints in other Cooper years