Suspension complaints by model year
Which parts fail
Components named in complaints (struts, shocks, control arms, ball joints, springs).
Mileage when the problem started
What owners report
Per the x69 warranty notice I had the crossmember replaced. The dealership states that Dodge does not cover the alignment that is needed due to the crossmember repair. The repair of the defect caused the need for the alignment. This seems to be a scam
The contact owns a 2011 Dodge Caliber. The contact stated while driving approximately 35 MPH, the contact heard an abnormal banging sound coming from the driver's side front wheel well while turning left or driving over bumps in the roadway. The contact stated no warning light was illuminated. The contact had taken the vehicle to an independent mechanic where it was diagnosed and determined that the front frame members were rusted, and the driver's side front steering arm had fractured and needed to be replaced. The vehicle had not been repaired. The manufacturer had not been informed of the failure. The contact stated that the mechanic was aware of a known manufacturer failure about the severe rusting of the frame. The failure mileage was 111,102.
Upon bringing our Caliber into a service shop to install shocks because we thought the severe vibration was from worn shocks, we were told the entire rear suspension subframe was rotted and rusted to the point of the driver-side rear was almost split in half. Had it been driven much farther, the left rear wheel would have been separated from the subframe. The shop did not want the car driven any further because of the safety risk to ourselves and others on the road and we had to fix this issue immediately. This is a grave issue of safety being this is a major frame component, that was clearly faulty and known about by Dodge, which could lead to a serious or fatal incident. The car has 139,000 miles on it and has been a good car mechanically thus far, prompting us to remedy the problem. …
The contact's daughter owns a 2010 Dodge Caliber. The contact stated while his daughter was driving at various speeds, she heard an abnormal sound and felt a vibration in the rear end of the vehicle. The contact stated that he had also noticed the failure while test-driving the vehicle. Upon inspecting the vehicle, the contact noticed that the rear cross member was severely rusted and had fractured. The dealer and the manufacturer were not notified of the failure. The vehicle was not diagnosed or repaired. The failure mileage was approximately 77,200.
The contact owns a 2010 Dodge Caliber. The contact stated that while making a right turn at 10 MPH, the vehicle kept turning. The vehicle was steered into a parking lot where it was observed that the passenger's side front axle had separated. The vehicle was towed to an independent mechanic where it was diagnosed that the cross member needed to be replaced due to corrosion. The vehicle was not repaired. The manufacturer was notified of the failure. The failure mileage was 125,000.
The contact owns a 2009 Dodge Caliber. The contact stated that upon taking her vehicle to an independent mechanic for a state inspection, she was informed that the rear subframe was severely corroded. The contact was informed that the corrosion had caused a significant hole to form on the rear subframe which could cause a severe failure while driving. The dealer was notified of the failure and the contact was informed that she would receive a callback. The manufacturer had yet to be notified of the failure. The vehicle had yet to be repaired. The failure mileage was 64,049.
The contact owns a 2009 Dodge Caliber. The contact stated while coming to a stop, there was a loud banging sound heard. Upon inspection, it was discovered that the front passenger's side wheel had detached due to a fractured lower control arm. The contact indicated that the failure was caused by severe rusting and corrosion of the subframe. The vehicle was not repaired. The manufacturer and local dealer were not notified of the failure. The failure mileage was 109,000.
Rear subframe rusted right through control rods snapped rear end of car dropped down. Upon researching they know that this is bad and unsafe even gave a 10 year extended warranty for front and rear subframe so how long will and how many complaints before this is an actual recall. I see here in your complaints that there is a large number of complaints on this issue. How are they getting away with this and nothing being done. I will have photos also police had said if this happened while it was on interstate would have crashed and could have been fatal. The tire would have ripped right off. So not only was my safety but the safety of the others being jeopardized cause everyone just keeps looking away at this issue. …
Frequently asked questions
Which Dodge Caliber years have suspension problems?
By NHTSA complaints, the 2007 (281), 2008 (118), 2009 (61), 2011 (30) and 2010 (26) model years. Suspension complaints make up 29% of all complaints for the 2007.
Is there a recall for Dodge Caliber suspension problems?
No. NHTSA lists no suspension recall for any Dodge Caliber model year. A widespread problem may still be covered by an extended warranty or a manufacturer service bulletin, so ask a dealer.
At what mileage do Dodge Caliber suspension problems start?
Across all years, half of the complaints with a recorded mileage happened before about 81,000 miles; 26% happened before 50,000 miles.
What part fails most often?
Owners most often name the front (58 mentions), followed by the front › control arm › lower ball joint (6).
Source: U.S. National Highway Traffic Safety Administration (NHTSA) — owner complaints through October 20, 2026, recalls and defect investigations; fuel economy from the EPA. Complaints are unverified reports and are not proof of a defect. How we rate model years.