Which parts fail
Components named in complaints (engine, cooling system, oil leaks, timing chain, exhaust).
Mileage when the problem started
Owner reports
Selected complaints filed with NHTSA by 2000 Daewoo Nubira owners, lightly cleaned up (personal details are redacted by NHTSA).
2000 Daewoo Nubira electrical system caught fire. Consumer would like compensation for the underhood fire. A short circuit within the wiring of the cam sensor ignited which resulted in a fire. The component had been recalled for similar make/model Daewoo vehicles. The consumer's vehicle was not included in the recall. Consumer sent in additional information in a voq. Updated 04/14/08.
04V357000/camshaft position sensor. The consumer experienced an underhood fire in March 2004 and since have had the vehicle repaired. The consumer has tried to contact the manufacturer to receive reimbursement now that the recall is in effect. The consumer stated that no one answered the phone. Provide further details.
Camshaft position sensor needs to be replaced for second time. I had to get the camshaft position sensor replaced at my cost. Second time it burnt one of the fuses out. I am unable to pay another time for this recall. Contacted Daewoo at the number placed on your website. They told me to contact dealership. Dealership refused to do recall work unless I paid for labor and part first and then contact Daewoo for reimbursement. I cannot get my tags which I already paid for because car will not pass smog. Dmv gave me one extension already. Tried to order part from several different auto parts stores. They stated this part is on back order and could take anywhere from two weeks to two years. Quality motor shop stated camshaft position sensor was a recall item. What good is NHTSA if you do not enforce dealerships or company to honor recall work?
When the consumer turned the key in the ignition, the vehicle accelerated without the gas pedal being depressed. The front brakes were noisy and were found corroded, a loud noise was coming from the A/C, the cup holder was inoperative, the tech found the fog lamp was inoperative, the trunk was inoperative, the tire was wearing uneven, both front control arms were noisy, there was an electrical wiring problem, the cam belt had broken and there was possible cylinder head damage, the vehicle would not start due to the timing belt which broke and caused the valves to bend. The consumer stated the rear brakes were noisy, there was a loud noise coming from the air condition, the fog lamp was inoperative, the hub cap was replaced, the trunk latch was replaced, the left and right control arms were replaced.
Recall 04V357000 concerning cam shaft position senor. The consumer received the recall notice regarding the camshaft positioning sensor. The consumer attempted to contact the manufacturer but ha not bee successful. The consumer has been unable to locate a service provider in his area because all the dealers previously associated with Daewoo no longer provide service on those automobiles. The vehicle was inspected by a dealer about 100 miles away. The dealer determined that he part was indeed faulty but the consumer would be financially responsible for replacing it because the part didn't fall within the lot #. The consumer request reimbursement for the repairs, travel expenses and hours missed form work.
Steering alinement problem, rattle in suspension, rear brake system seizes up, rebuilt. Grinding noise bearing and shafts replaced. Battery went dead, a week later engine blew a timing belt at 44967 miles. Steering went bad consumer was told upper and lower control arms were worn out and had to be replaced. NHTSA campaign id number : 04V357000 recall date : jul 12, 2004 component: engine and engine cooling. Campaign id number : 02V257000 recall date : sep 13, 2002 component: service brakes, hydraulic:foundation components:hoses, lines/piping, and fittings
The consumer received recall 04V357000 concerning cam shaft position sensor. Took vehicle to a Daewoo dealership. 3 hours later service manager was told by Daewoo that they were instructed to inspect the vehicle, but did not perform anything relating to the recall. The consumer was furious, and felt cheated because nothing was done. The check engine light illuminated on 10/11/03. The consumer was informed that the sensor had malfunctioned. The check engine light was currently illuminated.
On 7/26/04 while travelling at approximately 35 MPH, vehicle suddenly died. The timing belt went, damaging valves and cylinder head. Fortunately, vehicle had 57,000 miles and was under warranty. However, the front control arms/bushings/ sway bar were also bad. Unfortunately, these were not covered by warranty. Items were replaced. Now it seems the oil pump is going, oil is leaking and there is low pressure along with catalytic converter going. Dealer says these items will be covered.
I have a 2000 Daewoo Nubira with 71,000 miles on it. The timing belt broke, and now I also need a valve job. The owner manual states to change this at 72,000 miles and when I contacted the manufacture they stated that the warranty is for 5 years or 60,000 miles. I feel that the manufacture has complicity in making good on the cost of repair, as there manual then must be misleading or should have stated to be replaced at 60,000 miles or less.
04V357000/cam shaft sensor. Owner has received a recall notice from the manufacturer and went to the nearest dealership. The owner was informed by the dealership that they were not doing more than 5 vehicles per day and that they were currently booked and will not be able to accommodate the owner until November 2004. Owner feels the waiting time is unreasonable. Provide further details.
Related recalls
Engine and engine cooling
On certain passenger vehicles, the camshaft position sensor May melt resulting in a burning smell and visible smoke, which May subsequently lead to the melting of the camshaft cover and the camshaft position sensor wire harness.
Remedy: Dealers will replace the camshaft position sensors and install an additional fuse. Owners should contact Daewoo puerto rico at 1-877-362-1234 option 6.
Engine and engine cooling
On certain passenger vehicles, the camshaft position sensor May melt resulting in a burning smell and visible smoke, which May subsequently lead to the melting of the camshaft cover and the camshaft position sensor wire harness.
Remedy: Dealers will replace the camshaft position sensors and install an additional fuse. The recall began on September 7, 2004. Owners should contact Daewoo at 1-877-362-1234, option 6, or find a local dealer through their…
Engine complaints in other Nubira years
Frequently asked questions
How common are engine problems on the 2000 Daewoo Nubira?
NHTSA has 183 complaints about the engine & cooling of the 2000 Daewoo Nubira, 67% of the model year's 275 complaints. The component named most often is engine (16 mentions).
Is there a recall for 2000 Daewoo Nubira engine problems?
Yes — NHTSA recall 04V-394 (engine and engine cooling, Aug 6, 2004); NHTSA recall 04V-357 (engine and engine cooling, Jul 14, 2004). Recall repairs are free at authorized dealers.
At what mileage do 2000 Daewoo Nubira engine problems start?
Half of the complaints with a recorded mileage happened before about 47,000 miles, and 16% before 25,000 miles.
Is it dangerous?
Owners linked 1 crash, 3 fires and 2 injuries to engine & cooling problems on this model year. If you notice symptoms, have the car checked before driving further.
Source: U.S. National Highway Traffic Safety Administration (NHTSA) — owner complaints through October 20, 2026, recalls and defect investigations; fuel economy from the EPA. Complaints are unverified reports and are not proof of a defect. How we rate model years.