What gets recalled
2000 Volvo Acl recalls (4)
Steering › Linkages › Tie rod assembly
On some heavy duty class 8 vehicles equipped with arvinmeritor axle assemblies which May have been manufactured with trw model 20edl ball sockets, the tie rod ball-socket bearings have a below specification case depth and/or hardness which can lead to premature wear out of the socket in some applications.
Remedy: Dealers will replace the ball socket assemblies. This campaign supersedes NHTSA campaign nos. 01v-139.001 and 02v-037.002. Owner notification began July 25, 2002.
Suspension
Vehicle description: heavy duty 6x4 trucks equipped with chalmers 800 series suspension kits. These suspension kits May have insufficient penetration of the weld attaching the torque rod eye to the torque rod tube.
Remedy: Dealers will replace all chalmers fixed torque rods on these vehicles. Chalmers is conducting the owner notification and remedy for this campaign.
Wheels › Rim
Vehicle description: heavy duty trucks equipped with accuride 22.5 x 8.25 15 tubeless demountable rims, part no. 32051. Certain rims contain a non-fusion area in the butt-weld of the mounting ring. Under certain circumstances, the defect could develop into a crack on the mounting ring.
Remedy: Accuride will inspect and replace the defective or suspect wheel rims.
Service brakes, air › Antilock
Vehicle description: heavy duty trucks built with bendix air ABS with an ec-17 1030r electronic control unit (ECU), there have been reports of unwanted ABS activation at low speeds caused by 1) chafed ABS wheel speed sensor wires on rotating parts or 2) a damaged component at the wheel end that generates a certain type of…
Remedy: Dealers will replace the ABS ECU.
1999 Volvo Acl recalls (6)
Steering › Linkages › Tie rod assembly
On some heavy duty class 8 vehicles equipped with arvinmeritor axle assemblies which May have been manufactured with trw model 20edl ball sockets, the tie rod ball-socket bearings have a below specification case depth and/or hardness which can lead to premature wear out of the socket in some applications.
Remedy: Dealers will replace the ball socket assemblies. This campaign supersedes NHTSA campaign nos. 01v-139.001 and 02v-037.002. Owner notification began July 25, 2002.
Steering › Linkages › Tie rod assembly
Vehicle description: heavy duty, class 8, trucks equipped with tie rod assemblies containing 24-dl model ball sockets and manufactured by trw. Certain of the tie rod ball-socket bearings have a below-specification case depth and/or hardness, which can lead to premature wear of the socket.
Remedy: Dealers will replace the defective ball sockets and/or drag links. Owner notification began during May 2001. Owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the…
Steering › Linkages › Tie rod assembly
Vehicle description: heavy duty class 8 vehicles equipped with arvinmeritor axle assemblies which May have been manufactured with trw model 20edl ball sockets. The tie rod ball-socket bearings have a below specification case depth and/or hardness which can lead to premature wear out of the socket in some applications.
Remedy: Dealers will replace the ball socket assemblies. The campaign has been superceded by recall no. 02V037002. Owner notification began November 17, 2000.
Steering › Linkages
Vehicle description: heavy duty trucks equipped with trw 20-edl ball-socket assemblies. Certain of the ball-socket bearings have a below specification case depth and/or hardness which can lead to premature wear out of the socket. These bearings were produced between July 5 and October 3, 1999.
Remedy: Dealers will replace the ball-socket assemblies.
Show 2 more recalls
Service brakes, air › Antilock
Vehicle description: heavy duty trucks built with bendix air ABS with an ec-17 1030r electronic control unit (ECU), there have been reports of unwanted ABS activation at low speeds caused by 1) chafed ABS wheel speed sensor wires on rotating parts or 2) a damaged component at the wheel end that generates a certain type of…
Remedy: Dealers will replace the ABS ECU.
Fuel system, gasoline › Storage › Tank assembly › Filler pipe and cap
Vehicle description: heavy duty trucks equipped with a steel fuel tank. The closure only fuel tank cap, installed on the steel fuel tank, failed when the tank was dropped from a 10' height as required by FMVSS no. 393, "liquid fuel tanks."
Remedy: Owners will be provided with a new fuel tank cap.
1998 Volvo Acl recalls (5)
Service brakes, air › Antilock
Vehicle description: heavy duty trucks built with bendix air ABS with an ec-17 1030r electronic control unit (ECU), there have been reports of unwanted ABS activation at low speeds caused by 1) chafed ABS wheel speed sensor wires on rotating parts or 2) a damaged component at the wheel end that generates a certain type of…
Remedy: Dealers will replace the ABS ECU.
Parking brake
Vehicle description: heavy duty trucks equipped with haldex manifold dash valves (mdv) used in tractor and trailer parking brakes. These valves do not meet the requirements of FMVSS no.
Remedy: Dealers will replace the suspect valves.
Steering › Linkages
Vehicle description: heavy duty trucks equipped with a fal 8.0 front steer axle. The upper steering arm can fail without warning.
Remedy: Dealers will inspect the upper steering arm and replace it, if required.
Suspension › Front › Springs › Air suspension › Lines and fittings
Vehicle description: class 8 heavy duty trucks. The air suspension control valve supply line was not plumbed through an air pressure protection valve. In the event of a failure, there would be loss of air pressure in the 'b' system air reservoir that supplies air pressure for the front steer axle brakes.
Remedy: Dealers will install the necessary air pressure protection valve.
Show 1 more recall
Wheels › Rim
Vehicle description: heavy duty trucks equipped with aftermarket aluminum dual wheels, 22.5x8.25, one-piece, tubeless, supplied by accuride/akw. Certain design revisions combined with process conditions caused fatigue cracks in these wheels.
Remedy: Accuride/akw will replace these wheels.
1997 Volvo Acl recalls (6)
Service brakes, air › Antilock
Vehicle description: heavy duty trucks built with bendix air ABS with an ec-17 1030r electronic control unit (ECU), there have been reports of unwanted ABS activation at low speeds caused by 1) chafed ABS wheel speed sensor wires on rotating parts or 2) a damaged component at the wheel end that generates a certain type of…
Remedy: Dealers will replace the ABS ECU.
Parking brake
Vehicle description: heavy duty trucks equipped with haldex manifold dash valves (mdv) used in tractor and trailer parking brakes. These valves do not meet the requirements of FMVSS no.
Remedy: Dealers will replace the suspect valves.
Steering › Linkages
Vehicle description: heavy duty trucks equipped with a fal 8.0 front steer axle. The upper steering arm can fail without warning.
Remedy: Dealers will inspect the upper steering arm and replace it, if required.
Suspension › Front › Springs › Air suspension › Lines and fittings
Vehicle description: class 8 heavy duty trucks. The air suspension control valve supply line was not plumbed through an air pressure protection valve. In the event of a failure, there would be loss of air pressure in the 'b' system air reservoir that supplies air pressure for the front steer axle brakes.
Remedy: Dealers will install the necessary air pressure protection valve.
Show 2 more recalls
Wheels › Rim
Vehicle description: heavy duty trucks equipped with aftermarket aluminum dual wheels, 22.5x8.25, one-piece, tubeless, supplied by accuride/akw. Certain design revisions combined with process conditions caused fatigue cracks in these wheels.
Remedy: Accuride/akw will replace these wheels.
Suspension › Front › Wheel bearing
Vehicle description: class 8 heavy duty trucks. The steer axle wheel bearing jam nut lock washer May not have been bent over the jam nut after the wheel bearings were adjusted.
Remedy: Dealers will inspect the steering axle wheel bearing jam nut lock washer to determine if it is bent over the jam nut, and if not, repair as required.
1996 Volvo Acl recalls (3)
Suspension › Front › Springs › Air suspension › Lines and fittings
Vehicle description: class 8 heavy duty trucks. The air suspension control valve supply line was not plumbed through an air pressure protection valve. In the event of a failure, there would be loss of air pressure in the 'b' system air reservoir that supplies air pressure for the front steer axle brakes.
Remedy: Dealers will install the necessary air pressure protection valve.
Service brakes, air
The traction solenoid exhaust can be obstructed due to inadequate drainage and a build-up of road contamination between the mounting bracket and the solenoid housing. The obstructed exhaust prevents the relay valve control air pressure from venting after a differential braking traction event.
Remedy: Dealers will remove the suspect valve and install a new valve that has a modified solenoid housing which will allow for sufficient drainage and a new valve mounting bracket with increased height to reduce entry of…
Steering › Linkages
Vehicle description: heavy duty class 8 vehicles built with a Volvo 5.7 (12,500 lbs) front steering axle. Due to hydrogen embrittlement, the front steering axle king pins could have broken during assembly. Continued operation of a vehicle with a broken king pin could allow the pin to work loose.
Remedy: Dealers will inspect the vehicles for a broken king pin and replace the king pins if broken.
1995 Volvo Acl recalls (5)
Suspension › Front › Springs › Air suspension › Lines and fittings
Vehicle description: class 8 heavy duty trucks. The air suspension control valve supply line was not plumbed through an air pressure protection valve. In the event of a failure, there would be loss of air pressure in the 'b' system air reservoir that supplies air pressure for the front steer axle brakes.
Remedy: Dealers will install the necessary air pressure protection valve.
Service brakes, hydraulic › Foundation components
The rear most axle of the tandem axle set could have inoperable brakes on one or both wheels because the brake s-cam was incorrectly installed.
Remedy: Dealers will inspect the brake system and repair the s-cam assembly if found reversed.
Service brakes, air
The traction solenoid exhaust can be obstructed due to inadequate drainage and a build-up of road contamination between the mounting bracket and the solenoid housing. The obstructed exhaust prevents the relay valve control air pressure from venting after a differential braking traction event.
Remedy: Dealers will remove the suspect valve and install a new valve that has a modified solenoid housing which will allow for sufficient drainage and a new valve mounting bracket with increased height to reduce entry of…
Suspension › Rear › Springs › Air suspension system
The rear suspension axle retention plate can break under normal use, affecting axle alignment.
Remedy: Dealers will remove and replace the axle retention clip plates on affected vehicles.
Show 1 more recall
Service brakes, air › Controls, pedals and linkages
Undercoating applied to the inside of the cab shell squeezed out during assembly onto the brake pedal plunger.
Remedy: Dealers will clean the undercoating from the brake pedal plunger assembly, lubricate and reinstall the brake pedal plunger assembly.
Frequently asked questions
How many recalls does the Volvo Acl have?
NHTSA lists 18 recalls for the Volvo Acl across 6 model years.
How do I know if my Volvo Acl has an open recall?
Enter your 17-character VIN in our VIN decoder & recall check or on nhtsa.gov/recalls. Dealers fix recalls for free, even if you are not the original owner.
Source: U.S. National Highway Traffic Safety Administration (NHTSA) — owner complaints through October 20, 2026, recalls and defect investigations; fuel economy from the EPA. Complaints are unverified reports and are not proof of a defect. How we rate model years.