The problem
On certain vehicles, the hole in the sheetmetal front bulkhead that serves as the base and pivot point for the hood support rod was not punched to specification. The hood support rod May fail to hold the hood in position due to insufficient strength.
The risk
If the hood support rod hole fails, the hood could fall increasing the risk of injury.
The fix
Dealers will inspect the prop rod base hole and, if necessary, install reinforcement parts free of charge. The recall began on December 5, 2007. Owners May contact Honda at 1-800-999-1009.
Recall details
| NHTSA campaign | 07V-542 (07V542000) |
|---|---|
| Manufacturer number | Q64 |
| Manufacturer | Honda (American Honda Motor Co.) |
| Component | Structure › Body › Hood |
| Report date | November 21, 2007 |
| Owners notified | December 5, 2007 |
| Vehicles affected | 410 |
| Initiated by | Manufacturer |
Vehicles covered
Owner complaints about the body & structure
Frequently asked questions
Is the recall 07V-542 repair free?
Yes. Honda dealers will fix the problem at no cost: Dealers will inspect the prop rod base hole and, if necessary, install reinforcement parts free of charge. The recall began on December 5, 2007. Owners May contact Honda at 1-800-999-1009.
How do I know if my car is included?
Not every vehicle of the listed model years is affected — the recall covers 410 vehicles built in a certain window. Check your 17-character VIN with our VIN recall check or at nhtsa.gov/recalls.
Source: U.S. National Highway Traffic Safety Administration (NHTSA) — owner complaints through October 20, 2026, recalls and defect investigations; fuel economy from the EPA. Complaints are unverified reports and are not proof of a defect. How we rate model years.