What gets recalled
2004 Chevrolet Cavalier recalls (1)
Seat belts › Rear/other
Certain passenger vehicles fail to conform to federal motor vehicle safety standard no. 210, 'seat belt assembly anchorages.' the passenger-side rear safety belt May have been installed with an incorrect nut and bolt.
Remedy: Dealers are to inspect the safety belt anchorage and install a new nut and bolt, if necessary. The recall began on August 23, 2004. Owners should contact Chevrolet at 1-800-630-2438 and Pontiac at 1-800-620-7668.
2003 Chevrolet Cavalier recalls (1)
Exterior lighting › Turn signal
On certain passenger vehicles, the rear lamps that provide stop and turn signals and tail lamp functions stop working because of inadequate contact between the bulb and socket. In addition, if one bulbs were to become inoperative while the vehicle was operating in cruise control, the cruise control would disengage when the…
Remedy: Dealers will inspect the rear lamp bulb socket assemblies and apply grease or replace them if necessary. The recall began on January 18, 2005.
2001 Chevrolet Cavalier recalls (1)
Electrical system › Ignition › Switch
On certain passenger vehicles. If the engine fails to start and the driver holds the key in the "start" position for an extended period, high current flows through the ignition switch, and sometimes produces enough heat to melt internal switch parts.
Remedy: Dealers will install a relay kit in these vehicles to prevent high current from flowing through the ignition switch, and check that your car will start with a properly charged battery and, if necessary, replace the…
2000 Chevrolet Cavalier recalls (2)
Electrical system › Ignition › Switch
On certain passenger vehicles. If the engine fails to start and the driver holds the key in the "start" position for an extended period, high current flows through the ignition switch, and sometimes produces enough heat to melt internal switch parts.
Remedy: Dealers will install a relay kit in these vehicles to prevent high current from flowing through the ignition switch, and check that your car will start with a properly charged battery and, if necessary, replace the…
Interior lighting
Vehicle description: passenger vehicles equipped with the bi-fuel option fail to comply with FMVSS no. 101, "control location, identification, and illumination." the instrument panel lights in these vehicles are at full illumination levels and cannot be adjusted. The standard requires at least two levels of illumination.
Remedy: Dealers will replace the fuel type indicator switch assembly, which includes the instrument panel illumination control.
1999 Chevrolet Cavalier recalls (2)
Electrical system › Ignition › Switch
On certain passenger vehicles. If the engine fails to start and the driver holds the key in the "start" position for an extended period, high current flows through the ignition switch, and sometimes produces enough heat to melt internal switch parts.
Remedy: Dealers will install a relay kit in these vehicles to prevent high current from flowing through the ignition switch, and check that your car will start with a properly charged battery and, if necessary, replace the…
Interior lighting
Vehicle description: passenger vehicles. These vehicles do not comply with requirements of FMVSS no. 101, "control location, identification, and illumination." the instrument panel backlighting May not function after adjusting the interior light intensity.
Remedy: Dealers will test the body control module, and if necessary, replace it.
1998 Chevrolet Cavalier recalls (4)
Electrical system › Ignition › Switch
On certain passenger vehicles. If the engine fails to start and the driver holds the key in the "start" position for an extended period, high current flows through the ignition switch, and sometimes produces enough heat to melt internal switch parts.
Remedy: Dealers will install a relay kit in these vehicles to prevent high current from flowing through the ignition switch, and check that your car will start with a properly charged battery and, if necessary, replace the…
Steering › Rack and pinion
Certain passenger vehicles and Mini vans have lower pinion bearings in the power rack and pinion assembly in which the retainer tabs were not crimped properly. These and some other retainers used in vehicles assembled between January 1, 1996 and October 31, 1997, could fail and permit the ball bearings to escape.
Remedy: Dealers will install a new lower pinion bearing unless inspect of the existing bearing indicates that replacement of the gear assembly is necessary. Owner notification began January 24, 2003.
Fuel system, other › Delivery › Hoses, lines/piping, and fittings
Vehicle description: passenger vehicles equipped with bi-fuel compressed natural gas (cng) vehicles. The cng fuel line and the cng high pressure regulator coolant lines can contact other fuel (gasoline) and brake lines on the vehicle. Abrasion from contact can cause a leak in the brake pipe, fuel pipe, or both.
Remedy: Dealers will inspect and reposition the cng fuel and coolant pipes and reposition/repair any damaged fuel or brake pipes as necessary.
Wheels › Lugs/nuts/bolts/studs
Vehicle description: passenger vehicles. The wheel lug nuts were not tightened securely resulting in a fracture of the wheel studs.
Remedy: Dealers will inspect the torque of all wheel nuts and, if necessary, tighten any that May be below required torque.
1997 Chevrolet Cavalier recalls (7)
Steering › Rack and pinion
Certain passenger vehicles and Mini vans have lower pinion bearings in the power rack and pinion assembly in which the retainer tabs were not crimped properly. These and some other retainers used in vehicles assembled between January 1, 1996 and October 31, 1997, could fail and permit the ball bearings to escape.
Remedy: Dealers will install a new lower pinion bearing unless inspect of the existing bearing indicates that replacement of the gear assembly is necessary. Owner notification began January 24, 2003.
Electrical system › Ignition › Switch
On certain passenger vehicles. If the engine fails to start and the driver holds the key in the "start" position for an extended period, high current flows through the ignition switch, and sometimes produces enough heat to melt internal switch parts.
Remedy: Dealers will install a relay kit in these vehicles to prevent high current from flowing through the ignition switch. Owner notification began March 27, 2002.
Suspension › Rear
Vehicle description: passenger vehicles. One of the rear suspension trailing arm bolts can fatigue and break.
Remedy: Dealers will replace the rear suspension trailing arm fasteners.
Air bags
Vehicle description: passenger vehicles. Because of certain calibrations in the air bag's sensing and diagnostic module, an inadvertent air bag deployment could occur in a low speed crash or when an object strikes the floor pan.
Remedy: Dealers will recalibrate the air bag sensing and diagnostic module.
Show 3 more recalls
Structure › Body
Vehicle description: passenger vehicles. These vehicles were built with mis-located welds at the joint between the left rocker panel inner reinforcement and the body side ring. This does not meet the requirements of FMVSS no. 214, "side door strength."
Remedy: Dealers will inspect the welds and, if necessary, place five welds between the involved panels and apply primer and topcoat finish materials.
Wheels › Space saver wheel
Vehicle description: passenger vehicles. The compact spare tire assemblies were assembled with incorrect rims. If the spare tire is underinflated, the bead can separate from the rim causing a rapid loss of air. This does not comply with the requirements of FMVSS no. 110, "tire selection and rims."
Remedy: Dealers will replace the rim on the compact spare tire assembly. Owners are requested not to use the spare tire until the rim has been replaced.
Visibility › Windshield wiper/washer
These vehicles were built with an incorrect wiper blade assembly (17" long instead of 22" long) on the driver's side. This does not comply with FMVSS no. 104, "windshield wiping and washing systems."
Remedy: Dealers will inspect for the correct wiper blade assembly and install a correct length wiper blade assembly.
1996 Chevrolet Cavalier recalls (7)
Steering › Rack and pinion
Certain passenger vehicles and Mini vans have lower pinion bearings in the power rack and pinion assembly in which the retainer tabs were not crimped properly. These and some other retainers used in vehicles assembled between January 1, 1996 and October 31, 1997, could fail and permit the ball bearings to escape.
Remedy: Dealers will install a new lower pinion bearing unless inspect of the existing bearing indicates that replacement of the gear assembly is necessary. Owner notification began January 24, 2003.
Electrical system › Ignition › Switch
On certain passenger vehicles. If the engine fails to start and the driver holds the key in the "start" position for an extended period, high current flows through the ignition switch, and sometimes produces enough heat to melt internal switch parts.
Remedy: Dealers will install a relay kit in these vehicles to prevent high current from flowing through the ignition switch. Owner notification began March 27, 2002.
Suspension › Rear
Vehicle description: passenger vehicles. One of the rear suspension trailing arm bolts can fatigue and break.
Remedy: Dealers will replace the rear suspension trailing arm fasteners.
Air bags
Vehicle description: passenger vehicles. Because of certain calibrations in the air bag's sensing and diagnostic module, an inadvertent air bag deployment could occur in a low speed crash or when an object strikes the floor pan.
Remedy: Dealers will recalibrate the air bag sensing and diagnostic module.
Show 3 more recalls
Interior lighting
Vehicle description: passenger vehicles. These vehicles were built with the potential for the interior lamps to come on unexpectedly while the vehicles are being driven. This does not meet the requirements of FMVSS no. 101, "controls and displays."
Remedy: Dealers will run a diagnostic test on the lamp control module and, if necessary, replace it.
Exterior lighting › Hazard flashing warning lights
The front and/or rear hazard warning lamps (four-way flashers) do not flash when the hazard switch is activated. This fails to comply with FMVSS no. 108, "lamps, reflective devices, and associated equipment."
Remedy: Dealers or vehicle owners will inspect for proper function of the hazard warning lamps. If necessary, dealers will replace the hazard lamp switch.
Vehicle speed control
The accelerator control cable could have been kinked during assembly causing high accelerator pedal effort, sticking accelerator control cable, or a broken accelerator control cable.
Remedy: Dealers will replace the accelerator control cable assembly.
1995 Chevrolet Cavalier recalls (4)
Electrical system › Ignition › Switch
On certain passenger vehicles. If the engine fails to start and the driver holds the key in the "start" position for an extended period, high current flows through the ignition switch, and sometimes produces enough heat to melt internal switch parts.
Remedy: Dealers will install a relay kit in these vehicles to prevent high current from flowing through the ignition switch. Owner notification began March 27, 2002.
Exterior lighting › Hazard flashing warning lights
The front and/or rear hazard warning lamps (four-way flashers) do not flash when the hazard switch is activated. This fails to comply with FMVSS no. 108, "lamps, reflective devices, and associated equipment."
Remedy: Dealers or vehicle owners will inspect for proper function of the hazard warning lamps. If necessary, dealers will replace the hazard lamp switch.
Structure › Frame and members
Some welds were omitted from the body lock pillar, or "b" pillar. This does not comply with FMVSS no.208, "occupant crash protection."
Remedy: All vehicles in this recall campaign have been repurchased and replaced with a comparable vehicle.
Suspension › Front › Control arm › Lower arm
These vehicles have been built with welds missing from the front suspension lower control arm assemblies causing excessive loads on the existing welds.
Remedy: Dealers will inspect both left-hand and right-hand front suspension lower control arm assemblies and replace all control arm assemblies found with omitted welds.
Frequently asked questions
How many recalls does the Chevrolet Cavalier have?
NHTSA lists 19 recalls for the Chevrolet Cavalier across 9 model years.
How do I know if my Chevrolet Cavalier has an open recall?
Enter your 17-character VIN in our VIN decoder & recall check or on nhtsa.gov/recalls. Dealers fix recalls for free, even if you are not the original owner.
Source: U.S. National Highway Traffic Safety Administration (NHTSA) — owner complaints through October 20, 2026, recalls and defect investigations; fuel economy from the EPA. Complaints are unverified reports and are not proof of a defect. How we rate model years.